Hi folks, I have installed win10 on my Mi 8 with drivers, but when I try to boot I see only K letter in a blue circle logo and message:
main:initialize simple imp
Open config ‘simpleinit.static.uefi.cfg’ failed. Not found
Config: load failed
and I’m going back to boot menu
Besides of that I have an error: DRIVER PNP WATCHDOG and I can’t also run a Win image from USB as boot.image doesn’t recognize a USB drive.
Below are screenshots for Win 11, but I have tried with installing both Win10 and Win11 with no luck.
I have installed the windows on NFTS partition (85 GB nfts Name: win Flags: msftdata), with options Format and Bootable
then I have installed the drivers from WOA and I have ended up with Stop Code: Driver PNP Watchdog.
I am installing the drivers from the latest release from 25 May 2022 Releases · edk2-porting/WOA-Drivers · GitHub
I have also run all the commands from the installation solution.
What should I do now? What on the Disk D: should I check (maybe there are some logs for this)?
Recovery Your PC couldn’t start properly After multiple tries, the operating system on your PC failed to start, so it needs t be repaired.
Error code: Oxc0000001
You’ll need to use recovery tools If you don’t have any installation media (like a disc or USB device), contact your PC administrator or PC/Device manufacturer.
Press the Windows key for UEFI Firmware Settings
Recovery
Your PC/Device needs to be repaired The operating system couldn’t be loaded because the digital signature of a hie or one of its dependencies couldn’t be verified
You’ll need to use recovery tools If you don’t have any installation media (like a disc or USB device), contact your PC administrator or PC/Device manufacturer
Press the Windows key for UEFI Firmware Settings
I have installed 19044.1889_arm64_en-us_professional_a49c900b_convert
At the end, after installing OS and drivers I have also enbaled testing mode with
Enable Test-Signing mode
bcdedit /store Y:\efi\microsoft\boot\bcd /set {Default} testsigning on
bcdedit /store Y:\efi\microsoft\boot\bcd /set {Default} nointegritychecks on
What to do with that?
BTW, in drivers section, one of the drivers is described as unknown
Your PC/Device needs to be repaired The operating system couldn t be loaded because the digital signature of a file or of its dependencies couldn’t be verified
de. ‘WindowskSystern32\DriverStore\FileReposstory\qcpep.wd850inf_arm64_d4b893 b9dcf26e9e\qcpep850.sys
Error code. OK0000428
You’ll need to use recovery tools If you don’t have any installation media (like a du or USB device), contact your PC administrator or PC/Device manufacturer
Press the Windows key for UEFI Firmware Settings
EDIT: maybe it’s because in the first steps during partition creation I have recreated minidump partition? I don’t why blue screen is still popping up.
Even after flashing fastboot flash devcfg_ab devcfg-dipper_FixTS.img
I still see “Open config ‘\simpleinit.static.uefi.cfg’ failed. Not found. Config: load failed”
DisableIntegrityChecks is set to True
and AllowPrereleaseSignatures also to True, but under BcdStore\Loaders\WindowsSetup
under {bootmgr} it’s only DisableIntegrityChecks, but without AllowPrereleaseSignatures
I’m a rookie here so I used Visual BCD Editor, should I add something in {bootmgr} or {bootloadersettings}? to the {bootloadersettings} I have no access from Visual BCD
BTW via Mass Storage mode I have access to the esp partition stored here via Windows64 as I:\ and with Visual BCD editor I have an option to ‘repair bcd’ but I don’t know what this can done, so I don’t touch it